Theme: Hardware and Sensors
on 6/16/22, 1:08 PM • 634 views
I normally address new sensors on the fifth sensor connector. Can this fifth connector be used to connect a fifth sensor? If I leave a sensor connected in it, SGC doesn't see it on the dashboard, for example for the PH probe it says "missing", if I put the probe back on the fourth connector it is connected again.
I think in the description for the SGC it states that 5 probes can be connected as standard.
Please try to give a substantial answer. If you wanted to comment on the question or answer, just use the commenting tool. Please remember that you can always revise your answers - no need to answer the same question twice. Also, please don't forget to vote - it really helps to select the best questions and answers!
About This Community
|Asked: 6/16/22, 1:08 PM|
|Seen: 634 times|
|Last updated: 6/16/22, 4:29 PM|